OSC / LiveLink Streaming

YanusLIVE Pro can stream facial animation data to external applications through OSC or LiveLink.

OSC workflow

1. Open the Streaming Panel.

2. Enable OSC output.

3. Enter the target IP address.

4. Enter the target UDP port.

5. Start tracking.

6. Confirm that the receiving application gets OSC messages.

LiveLink workflow

1. Open the Streaming Panel.

2. Enable LiveLink output.

3. Configure the receiving application.

4. Confirm that the LiveLink subject appears.

5. Start tracking.

6. Verify motion in the target application.

Troubleshooting

• Check the target IP address.

• Check the port number.

• Check the firewall.

• Confirm that the receiving application is listening.

• Confirm that the correct protocol is enabled.